On 14 August 2011 20:14, V G wrote: > Please refer to the attached image. > > The picture shows two "bent" connections for Cff and Rfbb. I see this kin= d > of connection all the time. What are they implying by bending the schemat= ic > wire like that? Am I to connect them in a special way? > > -- > http://www.piclist.com PIC/SX FAQ & list archive > View/change your membership options at > http://mailman.mit.edu/mailman/listinfo/piclist > > The "bent" connection is used to prevent the 4 wires being connected at a single point. If they were shown straight, then it is easy to confuse the arrangement with 2 wires crossing, but not connecting. Or confusing a crossover with a connection. The "bent" implementation makes the designers intention clear and unambiguous. RP --=20 http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist .