Thinking about it now, they may not even be needed at all.  In fact,
they may be writing the wrong=20
 info to the config registers.  Just a thought.

Regards,

Jim

> -------- Original Message --------
> Subject: [PIC] MPLAB X, Hitech-C and configuration bits
> From: toftat@cowshed.us
> Date: Tue, July 26, 2011 11:15 am
> To: piclist@mit.edu
>=20
>=20
> I am having an issue getting the configuration bits set properly in my
> current project...
>=20
> The project is based on the 18F2321 part, using the MPLAB-X IDE and going
> to be written in Hitech C lite. I have defined my config bits in main.c a=
s
> follows:
>=20
> __CONFIG(1, INTCLKO & FCMDIS & IESODIS & PWRTDIS & BORDIS & BORV46);
> __CONFIG(2, WDTDIS & WDTPS32K & PBADDIS & LPT1DIS & MCLREN);
> __CONFIG(3, DEBUGDIS & XINSTEN & STVREN & LVPDIS);
>=20
> hoping to get the chip running on the internal oscillator with the clock
> output, and most everything else disabled, unless I don't understand it a=
t
> which point I left it as default.
>=20
> I am seeing 2.5v DC on the OSC pins rather than the expected square wave,
> and the pin toggle that is later in the program doesn't occur either.
>=20
> When I read the program back, it appears that oscillator is set to HSPLL
> (between the * below)
>=20
> :020000040030CA
> :0E000000*0006*1F1F0083850003C003E00340BD
>=20
> So I am asking the following...
>     Have I defined the configuration bits correctly? If not, how should I
> define them?
>     Is there an IDE setting that might be overriding the contents of the
> file? I vaguely remember such a setting in MPLAB 8, but I cannot find
> any documentation for MPLAB-X
>=20
> Thanks
>=20
> Anthony
>=20
>=20
> --=20
> http://www.piclist.com PIC/SX FAQ & list archive
> View/change your membership options at
> http://mailman.mit.edu/mailman/listinfo/piclist


--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.