Did you have success ? If you did ..... share your expertise with the nex= t person who wants help. 99guspuppet > On Jun 21, 2011, at 5:11 PM, yamanoor sairam wrote: >=20 > Thank you >=20 > Sai >=20 >=20 >=20 > ________________________________ > From: YES NOPE9 > To: Microcontroller discussion list - Public. > Sent: Saturday, June 18, 2011 8:40 PM > Subject: Re: [EE]: Pressure sensor signal conditioning and constant curre= nt supply circuit >=20 >>=20 >> On Jun 18, 2011, at 11:02 AM, yamanoor sairam wrote: >> ( snip ) >>=20 >> Also, the pressure sensor is really small and requires SMT soldering. I = tried soldering it to a general purpose PCB board prototyping board but fai= led in doing so. I would like to hear the group members recommendation for = soldering on top of a prototyping board. >>=20 >> Are there any low cost sensors apart from this Mouser one that has a lin= ear output and could be used for Medical applications? >>=20 >> I apologize for too many questions in the same mail. >>=20 >> Thanks, >> Sai > Glue the part down and then solder the tabs using a very fine soldering t= ip. > Or get an SMT proto board and cut a piece of it out for your part and glu= e this to the other proto board. > 99guspuppet > - --=20 http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist .