Thank you Sai ________________________________ From: YES NOPE9 To: Microcontroller discussion list - Public. Sent: Saturday, June 18, 2011 8:40 PM Subject: Re: [EE]: Pressure sensor signal conditioning and constant current= supply circuit >=20 > On Jun 18, 2011, at 11:02 AM, yamanoor sairam wrote: > ( snip ) >=20 > Also, the pressure sensor is really small and requires SMT soldering. I t= ried soldering it to a general purpose PCB board prototyping board but fail= ed in doing so. I would like to hear the group members recommendation for s= oldering on top of a prototyping board. >=20 > Are there any low cost sensors apart from this Mouser one that has a line= ar output and could be used for Medical applications? >=20 > I apologize for too many questions in the same mail. >=20 > Thanks, > Sai Glue the part down and then solder the tabs using a very fine soldering tip= .. Or get an SMT proto board and cut a piece of it out for your part and glue = this to the other proto board. 99guspuppet --=20 http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist --=20 http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist .