> I tried lengthening a number of areas........sometimes has
> caused more glitches

Sounds odd. LCDs are usually pretty solid once you find out
what they like. You're not missing another cure are you ? eg
filter cap(s) right at the LCDs power pads. I've had to do that
a couple of times with modules that wouldn't initialise. It might
not be necessary but it shouldn't do any harm

> Any suggestions for what to put on the enable line?

Not really. I'd be more interested in hunting down the noise. I
use both individual wiring and ribbon cable, all sorts of lengths,
but not seen your problem. That it happens when you remove
the analyser probe sounds like a good place to start. A probe
would not be able to match a driven PIC pin for impedance.
Perhaps some sort of earthing trouble or missing connection
that's helped by the analyser. The Enable line isn't going hi-Z
through s/w by accident is it ?

Joe
--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.