>=20
> On Jun 18, 2011, at 9:39 PM, IVP wrote:
>=20
>> grab the can at the two ends.
>> Spin the can up to 10,000 RPM.
>=20
> I think Russell was wanting to cut the can lengthwise, to make
> two troughs


#1   Use parallel suction ports to hold aluminium wall steady and cut betwe=
en them with dremel cut-off wheel..
#2   fill can with steel beebees and use magnets to hold aluminium wall ste=
ady and cut between them with dremel cut-off wheel..
99guspuppet


--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.