On Thu, Jun 9, 2011 at 9:17 PM, Carey Fisher <careyfisher@ncsradio.com>wrot=
e:

> Couple more tips:
> 1.  Try to keep silkscreen markings off of solder pads (R1, R2, etc).  Ma=
y
> cause issues with soldering and (obviously) you can't read them.
> 2.  Use high intensity LEDs.  You can get LEDs that only need a few mA bu=
t
> are plenty bright.
>

Thanks! The LEDs that I found are pretty good. And I don't care about the
silkscreen at all. I'll probably just delete that layer. I don't need to se=
e
the markings on the PCB, I know where the components go. If I try and space
everything out, it takes up board space.

What's the worst that could happen by submitting the board like that?
--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.