On Wed, May 25, 2011 at 3:51 AM, Geo <buggiesmith@gmail.com> wrote:

> You did not look at rotating the LEDs 180 degrees so that their anodes
> were closer to the drivers and the cathodes to the resistors - would
> have saved some ugly routing.
>

Done.


> I would have made the power and ground tracks 50 thou.
>

Couldn't afford to make them 0.050 inches. The default net class is 0.013"
width, 0.013" clearance. I made the GND net 0.020", 0.015". There's not muc=
h
current flowing through them anyway. The LEDs are the biggest current drain=
s
on there. Also, the drains on the MOSFETs, so I'll make those a bit bigger
too.

Thanks for the suggestions.
--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.