On Sun, 15 May 2011 03:45 +0000, "Jason White" wrote:
> Hello all, I like to know what would be the most effective - as in quick,
> reliable, and cheap way to desolder all of the through-hole components
> from
> large (12x12 in, FR-2) boards.
>=20
> I'm currently using a propane torch and pliers to remove components,
> basically this consists of holding the board over the torch and tugging
> on
> the selected competent with pliers. This usually results in setting fire
> to
> the board several seconds before the components solder melts completely.
>=20
> This is rather slow and produces quite a bit of smoke, what could I do to
> streamline the process and do less damage ? (methods of heating,
> component
> removal techniques, tools, etc)

Hot air gun, such as one would use for paint stripping, works for me.

Bob

--=20
http://www.fastmail.fm - Or how I learned to stop worrying and
                          love email again

--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.