On Tue, 22 Mar 2011 15:20 -0700, "Ing. Marcelo Fornaso" wrote:
> I'm a little afraid of using this sheets on my laser printer because
> their=20
> surface looks like plastic...
>=20
> Don't you think there is any risk of fusing it into the printer?

With label attached it is intended to run through a printer. I haven't
ever had a problem.

It is too slippery to hold the toner until you scuff it up a little bit
with a tissue or paper towel.

I don't run it full letter size through the printer. I attach a piece
larger than the design on to a sheet of normal paper using a label at
the top of the backing paper. Center the design on the sheet so the
leading edge of the carrier paper has nothing additional on it.=20

Cheers,

Bob

--=20
http://www.fastmail.fm - A no graphics, no pop-ups email service

--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.