> Only (small) thing I can spot is to be careful the crystal case does
> not short the traces it sits over, with there being no mask on the
> board - you could just make sure it's raised a bit (or hand paint
> some mask on if you have a touch up pen/lacquer or something)

SMT crystals have an insulating pad on the bottom. Maybe add
something similar. Anything would do, like a piece of mica, thin
rubber or card. Only takes a minute, won't hurt to

> I would maybe make your pad rings a bit thicker

Agreed. Pads always come out looking smaller physically than
you thought they looked on paper. Make them as big as you
have room for. Plus it helps if you need to re-work the board.
Bigger pads will take more wear-and-tear

Joe
--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.