At 03:06 PM 12/22/2010, Nathan House wrote:

>For now I'm getting pretty good results with the toner transfer method:
>
>http://www.roboticsguy.com/tutorials-/electronics-/pcb-/making-pcbs-toner-=
transfer-/images/l297-l298-printed-circuit-board-pcb-diy.jpg
>http://www.roboticsguy.com/tutorials-/electronics-/pcb-/making-pcbs-toner-=
transfer-/images/pcb-traces-close.jpg

I'd say that you are getting darned good results!

I'll make a suggestion, if I might.

I would edit your footprints to have much smaller holes.  You need=20
only enough of a hole for the drill bit to center itself within.

I would think that soldering components to your PCB would be fairly=20
difficult because of the amount of area where there is no solder.

Just a suggestion . . .

dwayne

--=20
Dwayne Reid   <dwayner@planet.eon.net>
Trinity Electronics Systems Ltd    Edmonton, AB, CANADA
(780) 489-3199 voice          (780) 487-6397 fax
www.trinity-electronics.com
Custom Electronics Design and Manufacturing

--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.