>> The iPhone isn't looking for a "steady voltage", it's looking for a
>> ratio between lines, exactly what using resistors gets you, so the
>> obvious solution? Use resistors.

> Where did you get this information from?

Even if you don't follow Herbert's advice, you could consider using my
already completed Googling of several days ago.

I provided links to discussion of the  IC used, how to use resistors
to set charge rate, circuit diagram of how to use resistors, values to
use to achieve desired result, photo of inside of phone with charging
IC identified, link to data sheet of IC. The data sheet discusses how
the resistor method works and I have pointed out, perhaps several
times, that that information is in the IC data sheet (LTC4066).

If you always followed all the links that I provide you with you'd be
an international expert* in no time :-)


               Russell

* Area of thus acquired expertise cannot be guaranteed.
--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.