Same-ish here.  I use regular screw-terminal blocks for this, and =20
ensure that the reference junction is inside the enclosure, with the =20
temp sensor next to the terminal block, on the side the wires connect =20
to.

Cheers,
-Neil.



Quoting peter green <plugwash@p10link.net>:

> Do you actually need a special thermocouple connector? Last time I
> needed to hook up a thermocouple I just used an ordinary micro spox.
>
> Afaict all you achive by using a special connector is moving the
> reference junction from the cable-connector interface to the
> connector-pcb interface. That gets the reference junction slightly
> closer to whatever temp sensor you are using as a reference but I doubt
> it will make much difference in practice.
>


--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.