Ok, thanks for the advice everyone. I'm going to be using a Bluetooth
module that may require some initial setup via serial port. Rather
than also build an RS232->3.3V converter, I was hoping the UART tool
would suffice. Since this is just for my prototype, I'll likely be
typing settings in by hand. Eventually I'll probably make a custom
firmware for my PIC that configures the module.

Sounds like the UART tool should work for me, so I'm happy!

Thanks,

Josh
--=20
A common mistake that people make when trying to design something
completely foolproof is to underestimate the ingenuity of complete
fools.
=A0 =A0 =A0 =A0 -Douglas Adams

--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.