I haven't used their 4-layer service, but I've had great results with the special price prototype service at GoldPhoenix: http://goldphoenixpcb.biz/special_price.php They are (or at least were) the service behind Sparkfun's Batch PCB service= .. -n. On Mon, Nov 8, 2010 at 4:23 AM, wrote: >> 2. Spirit Circuits - I've also used this place and their not the >> cheapest, but excellent quality/service. Also, they do a very cool >> *FREE* 2 layer "Go Naked" prototype service, which is worth knowing >> about. Very innovative/ modern kind of place, seem to make an effort > to >> impress. You may want to check out their "PCB Snap" for a 4-layer > prototype. >> http://www.spiritcircuits.com/home > > Is this really limited to 2 layer? I have checked over their website > since you had your board done, and can find no reference to it being > limited to 2 layer. If it really is 2 layer it is a bit annoying, as in > many circumstances one would also want power and ground planes to make a > decent attempt at a prototype PCB. I also have a small board that I want > to use to try their 'Go Naked' which really needs 4 layers. > > ... >> 5. Olimex - from Bulgaria, may have been the Eastern Europe place you >> had in mind. Cheap and cheerful but I think only up to 2 layer... >> http://www.olimex.com/pcb/index.html > > Do note that there are significant restrictions on the drill sizes and > trace width/spacing you can use for the proto service. If you really > want to use sizes and width/spacing outside those set out on the web > page then there are significant costs involved. > -- > Scanned by iCritical. > > -- > http://www.piclist.com PIC/SX FAQ & list archive > View/change your membership options at > http://mailman.mit.edu/mailman/listinfo/piclist > --=20 http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist .