On Thu, Sep 23, 2010 at 2:22 AM, ivp <joecolquitt@clear.net.nz> wrote:
> Hi all
>
> I have a project which needs two timing intervals set. I did the
> proof-of-concept with a 16F88 but would like to use a 12F675
> in the actual product
>
> Using the 8 pins of the F88's PortB, each interval was set digitally
> with its own 4-way DIP switch. ie B<3:0> and <7:4> ranged 0-F
> individually. The value for each nybble is the counter for a 10ms
> timer, so Interval1 can be set from 0 to 150ms, and likewise Interval2
> also from 0 to 150ms
>
> I have two A/D pins free on the 12F and can use those to measure
> distinct voltages. That could be done with two 12-way rotary
> switches + resistors, possibly using a 12ms timer to get the same
> approximate range
>
> My preference would be to use the 4-way DIP switches initially
> and probably replace those with solder bridging pads later once
> the client has a better idea of what the optimum settings are
>
> Referring to the attached drawing, is there an algorithm to determine
> the values of the resistors so that the A/D can best discriminate a
> voltage which corresponds to the binary setting of the DIP ? Or has
> anyone done or seen this done before ?
>
> TIA
>
> Joe
>
> *
> *
> **********
> Quality PIC programmers
> http://www.embedinc.com/products/index.htm
> --
> http://www.piclist.com PIC/SX FAQ & list archive
> View/change your membership options at
> http://mailman.mit.edu/mailman/listinfo/piclist
>
>

That scheme was common with remote controls for portable minidisc/CD
players. See http://www.minidisc.org/manuals/sharp_mdmt20_remote_schem.pdf
for an example.
--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.