You could delete them or comment them.  And if the code you are using uses =
those=20
leds then you should comment that on the code too. =20

Another approach (at least to let you compile) will be to replace the LEDs=
=20
definition by a Nop().  Check if that works (of course it depends on the co=
de). =20


If that works, is time to remove all the code in the project that is relate=
d to=20
the LEDs.  May be you took an example code that uses leds but they are not =
part=20
of the stack as far as I remember,

I hope this helps
Regards,
Mauricio





________________________________
De: Steve Maroney <steve@bcsupportllc.com>
Para: Microcontroller discussion list - Public. <piclist@mit.edu>
Enviado: mi=E9rcoles, 1 de septiembre, 2010 15:06:42
Asunto: [PIC] Microchip TCPIP

Hello gang,



I'm attempting to use Microchips TCPIP stack with a PIC18F2550. There
are pieces of code in the files from microchip that are related to
buttons and LEDS that I think has to do with thier demo boards. I see
where they are defined in Hardwareprofile.h.  Again, I'm only using
these files on a PIC18F2550, not a demo board or starter kit. =20



These buttons and LEDS are not letting me compile successfully.   What
am I doing wrong ?





Best Regards,

Steve Maroney





--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist



     =20
--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.