If I'm reading the web site correctly, it's $5 for 3 copies of a 1 square i= nch=20 board, not $5 for each copy.=A0 So you are really getting 3 square inches f= or $5. ________________________________ From: Wouter van Ooijen To: Microcontroller discussion list - Public. Sent: Thu, August 12, 2010 1:47:38 PM Subject: Re: [EE] SUPER cheap PCB manufacturing > Price is $5US per square inch of board size.=A0 For that price, you get > three copies (i.e., a board 1 inch (25mm) to a side costs $5, and > you get three of them).=A0 Shipping inside the US is included, and he > does a flat rate to foreign addresses. Compare to Olimex: E 30 gets you one 100x160 mm (160 cm^2), panelized as=20 you specify. No requirement to take 3. $5/inch^2 =3D $5/6.45cm^2 =3D $125/160cm^2 So dorkbot is OK if you need 3, but Olimex is much cheaper if you need 1=20 and you can fill a eurocard with your designs. (For simplicity I omitted S/H aspects, Olimex's drill requirements,=20 Olimex discount on 5+, etc) --=20 Wouter van Ooijen -- ------------------------------------------- Van Ooijen Technische Informatica: www.voti.nl consultancy, development, PICmicro products docent Hogeschool van Utrecht: www.voti.nl/hvu --=20 http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist --=20 http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist .