> On 8/6/2010 12:02 PM, Bob Blick wrote:
>   =20
>> Backlight draws too much current?
>>
Backlight not hooked up yet. Last error message I got was:=20
"PK2Error0027:  Failed verify (Address =3D 0x0 - Expected Value 0xEFAE -=20
Value Read 0x0)", which is different, previously got Vpp error, which in=20
part says:
PIC18F devices may require up to 10 uF of capacitance on the VDD pin to=20
program properly.

I have had the 10 uF, and made the changes to the MCLR and control=20
line.I believe this is still pointing to the PGD and PGC lines, which I=20
will attack next. The error goes away (as previously) when the LCD is=20
disconnected.

Per Olin's link, PGD should have 100 ohm to the programmer and a 47 -=20
100 pf to ground. The PGC should have a 47 pf. Originally I asked about=20
resistor values on the pins going to the application, and these go to=20
the programmer. Think I'll try Olin's way first.

I do have a WIRZ-OEM RS-232 to LCD board. The LCD works OK with it.
--=20
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
.