On Wed, Jul 28, 2010 at 5:15 PM, RussellMc wrote: >> > The simplest way is using a small thermos, put inside all your >> > electronics and close it hermetically. >> Thanks. That's a really good idea. Even an airtight lunch box should >> do. Never thought of that. > > Yes - a sealed container is a good idea > But several people have suggested similar already. > If the idea of using a sealed plastic box seems like a suddenly good > suggestion then perhaps you are not receiving all posts, or not > reading all that you receive on the subject. Russel, a sealed plastic box is not a thermos. A thermos is a glass with double walls and vacuum between walls. An 100%RH at 8C in the outside atmosphere will not create condensed water in the inside except maybe at the cork (with a proper cork will be avoided there too). Now maybe you can understand better. Vasile > > eg from a prior post: > > If you *ABSOLUTELY* must put the controller inside the high humidity shel= l: > > - Seal the controller in its own dry air environment. > > - In situations where an item MUST share the high humidity air, > consider the possibility of maintaining the controller at a suitably > higher temperature. This will lower the *effective* RH of air which > comes in contact with it. > > _______ > > There have been a few other similar suggestions. > > > > =A0 =A0 =A0 =A0 =A0 =A0 =A0 =A0R > -- > http://www.piclist.com PIC/SX FAQ & list archive > View/change your membership options at > http://mailman.mit.edu/mailman/listinfo/piclist > --=20 http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist .