On Tue, 06 Apr 2010 17:23:44 +0100, you wrote:

>On Tue, 6 Apr 2010 17:07:23 +0100, you wrote:
>
>>>>Does Farnell 908-654 not work for you?
>>>
>>> No - too thick (too much spring) and I don't have room for the corners - 
>>> Overall outline can't be
>>> much  more then the cell and 2 small tabs for soldering.
>>> This is to fit a pre-existing case from a product which used the small 
>>> clips - we know we can get
>>> the empty cases but don't yet know about the clips.
>>> The case is just too good a fit for our product to be thwarted by 
>>> something as trivial as battery
>>> clips..!
>>
>>Did you check the datasheet, as the picture on the Farnell page is 
>>definitely wrong. The datasheet pictures do look more like what you want, I 
>>thought. 
>
>Thanks - I didn't think to look further as all other sources I looked at were showing the same
>larget Keystone part  - drawing not very clear but will order some to look at. 
>
>Rather expensive though....

Actually looking again at the data, the low-profile 3003 one is through-hole. The SM 3002 ones are
too tall and wide - I think the ones shown on the green strip on the PDF page are maybe for smaller
cells. 

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist