In SX Microcontrollers, SX/B Compiler and SX-Key Tool, olivedrab wrote:

Please see code attached-  A few questions I have. 

#1--  I'm wondering if I can stop the timing sequence after PButton2 is pressed by pressing PButton2 again anytime during the sequence(during RCTIME)?  Hope that made sense?  I need to be able to stop the program during the pause for safety reasons if possible.  (This is the closing of a panel.)    

#2--  At this point I need to press PButton1 to go fully open again while making PButton2 non-functional until next program start.  (This only allowing the panel to open again no matter if you try and keep pressing PButton2 to close.)  

  Not quite sure how to correct this problem.  Thanks!!  

                               Greg

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=438115

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2010 (http://www.dotNetBB.com)