Wouldn't it be possible to design a component with one
(or several for that matter) normal rectangular through
hole pads, with a drill diameter of 0. It is definitely possible
in my "Number One Easy-PC".

PerL

----- Original Message ----- 
From: "Vitaliy" <piclist@maksimov.org>
To: "Microcontroller discussion list - Public." <piclist@mit.edu>
Sent: Friday, March 12, 2010 11:26 PM
Subject: Re: [EE] EAGLE question: device w/ pads on top and bottom


> "M.L." wrote:
>> I'm pretty sure there's no way to have two pins in a schematic
>> connected to one pad/pin on a board without violating DRC. I.e. you
>> could force a connection by drawing a wire on the physical part model
>> but it will give you hell when you do a DRC.
> 
> No, actually I'm trying to connect ONE schematic pin connect to TWO pads.
> 
> The metal clip, remember? It's one part, one signal, but it connects to two 
> pads on the edge of the PCB (top and bottom).
> 
> Vitaliy 
> 
> -- 
> http://www.piclist.com PIC/SX FAQ & list archive
> View/change your membership options at
> http://mailman.mit.edu/mailman/listinfo/piclist
>
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist