On Fri, Mar 12, 2010 at 5:26 PM, Vitaliy wrote: > "M.L." wrote: >> I'm pretty sure there's no way to have two pins in a schematic >> connected to one pad/pin on a board without violating DRC. I.e. you >> could force a connection by drawing a wire on the physical part model >> but it will give you hell when you do a DRC. > > No, actually I'm trying to connect ONE schematic pin connect to TWO pads. > > The metal clip, remember? It's one part, one signal, but it connects to two > pads on the edge of the PCB (top and bottom). > > Vitaliy I realized that after I sent it, but the same applies. Pins and pads are 1 for 1. -- Martin K. -- http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist