"M.L." wrote:
> I'm pretty sure there's no way to have two pins in a schematic
> connected to one pad/pin on a board without violating DRC. I.e. you
> could force a connection by drawing a wire on the physical part model
> but it will give you hell when you do a DRC.

No, actually I'm trying to connect ONE schematic pin connect to TWO pads.

The metal clip, remember? It's one part, one signal, but it connects to two 
pads on the edge of the PCB (top and bottom).

Vitaliy 

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist