In SX Microcontrollers, SX/B Compiler and SX-Key Tool, gator wrote:

I tried 3.3.0, 3.5BETA, 3.2.3 and SX52key.exe (yes, an old one).
I have two PCB's, same layout, two different SX52 chips.
On the PCB are just the 10k resistor and some block condensators, SMD only.
Basically I used SX-Key Rev. F in the past to flash approx. 1,000 chips.
I bought a new USB SX-Key Rev. B yesterday.
And I used several types of power supplies.
I know that 
My device section is: sx52, oschs3
After programming the status shows up with "Running" and
all buttons except Reset are gray. 
I have no clue what to do...
Is there any documentation about the signals I could trace with a scope?
Thanking in advance for every advice.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=432894

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2010 (http://www.dotNetBB.com)