Xiaofan Chen wrote:
> This photo is also not good. It is cut off to the right.
> http://www.embedinc.com/products/usbprog2/eusb4_1_1024.jpg

I was trying to show both ends of the box, which is why that picture is
right next to http://www.embedinc.com/products/usbprog2/eusb4_2_1024.jpg
showing the other end of the box.  I'll look into maybe a third picture
showing the whole box.

> The cost adder of USB-Prog 2 compared to USB-Prog is US$45
> and IMHO it deserves a better looking casing.

You still haven't said what constitutes "better looking" other than not so
tall.  I'd like it flatter too, but couldn't find a suitable box off the
shelf.  One thing I don't like is the T1 LED sticking out.  I'd really
rather have a light pipe press fit into the hole, then the other end of the
light pipe ending right above a SMD LED on the board.  I looked into that,
but couldn't find any way to do it for a reasonable cost at the expected
volume.

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist