Ahhh! I didn't know I had to do that, but it is in the extended instruction set part of the docs. How do I turn it on? Although, I may just try the "INCF FSR0L,1" instead. Joe M. Tamas Rudnai wrote: > I think you need to switch on the extended instruction set to have > ADDFSR instruction. > > Tamas > > > On Mon, Feb 8, 2010 at 11:56 PM, MCH wrote: >> A week or so ago, I asked for some ASM code and stated I could translate >> it to my current device. Someone commented that "ASM code was ASM code" >> (paraphrased) and there was no need to translate. >> >> Well, I need some help with the "unnecessary" translation. >> >> Here is the command in ASM for a PIC16F877A: >> INCF FSR,F >> >> I think this translates to: >> ADDFSR 0,H'1' >> >> But, I'm getting an error code of: >> Warning[207] C:\(file).ASM 667 : Found label after column 1. (ADDFSR) >> >> There is only a tab before the ADDFSR - just as the other lines of code. >> >> Can anyone help me with this translation? Oh, and would I need to use >> H'2' since this is an 18F to increase to the next address pointer? I >> remember having to 'double' most of my relative addresses. >> >> I'm working on something other than my fan, for which I still am trying >> to determine the best solution. >> >> Joe M. >> -- >> http://www.piclist.com PIC/SX FAQ & list archive >> View/change your membership options at >> http://mailman.mit.edu/mailman/listinfo/piclist >> > > > > > ------------------------------------------------------------------------ > > > No virus found in this incoming message. > Checked by AVG - www.avg.com > Version: 9.0.733 / Virus Database: 271.1.1/2676 - Release Date: 02/08/10 14:35:00 > -- http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist