In SX Microcontrollers, SX/B Compiler and SX-Key Tool, mghodge wrote:

I think you're going to need some kind of transient tolerance in your software.  Say start a counter when you sense that input going active and then after a short period if it's still active, then trigger your response.  Also, have you measured how much current your two resistors are pulling from your batts?  You may want to do as suggested above and only "enable" them when you want to test the batt level.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=348367#m418552

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2010 (http://www.dotNetBB.com)