> One additonal comment....where I have connections going in 2 directions,
> around the LEDs for example, I usually line up the junctions, one part going
> up, the other down in this case, just to minimize the number of junctions on
> the page.
>   
OTOH I've seen advice from some sources (don't remember where) not to 
use cross junctions because they mean a missed dot can hugely change the 
meaning. This is probablly less of an issue with computer draw 
schematics though.


-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist