Hi,

I am using a PIC18F2525 with MPLAB 8.30 and ICD3 and I am trying to debug c=
ode =

using Timer1.

I use an ceramic resonator at 20MHz and have set OSC=3DHS. Timer1 is config=
ured =

to run in timer mode with FOSC/4 as clock. However, when I single step with =

timer1 on, the timer seems to be free running even when the debugger is hal=
ting =

the PIC. This continuously fires the timer1 overflow interrupt and I get in=
to =

the ISR when stepping over/into next instructions.

The timer works as expected when I try the code with the simulator.

So, when the debugger (ICD3) is halting the processor - should timer1 conti=
nue =

counting?

Actually, looking at Timer0 it has the same behavior - still counting when =
the =

processor is halted.

Is it not possible to debug with ICD3 using a ceramic resonator as clock =

source?

/Ruben
=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=
=3D=3D=3D=3D=3D
Ruben J=F6nsson
AB Liros Electronic
Box 9124, 200 39 Malm=F6, Sweden
TEL INT +46 40142078
FAX INT +46 40947388
ruben@pp.sbbs.se
=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=
=3D=3D=3D=3D=3D

-- =

http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist