Hi, Vitaly,

Have you tried the Apro forum? I'm guessing you might have better =

success with your question there.

http://sourceforge.net/projects/tpapro/forums


Mark Skeels
Engineer
Competition Electronics, Inc.
TEL: 815-874-8001
FAX: 815-874-8181
www.competitionelectronics.com


Vitaliy wrote:
> I can't really post the code, unless I post the entire project.
>
> Yes, the code had been working fine without the lines shorted.
>
>
> ----- Original Message ----- =

> From: "Mauricio Giovagnini" <maugiovagnini@yahoo.com.ar>
> To: "Microcontroller discussion list - Public." <piclist@MIT.EDU>
> Sent: Friday, November 20, 2009 11:52
> Subject: Re: [EE] AsyncPro question
>
>
>
> Vitaliy escribi=F3:
>   =

>> Not using flow control, it's basically a three wire interface (Rx, Tx, =

>> Gnd)
>> with Rx shorted to DCD.
>>
>> The program is written in Delphi 7.
>>
>>     =

>
> I admit I haven't wired DCD shorted to the RX pin, and I
> will not but just to know , can you post your code? Can you
> make your code work without shorting those lines?
>
>
>
>
>   =

-- =

http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist