I can't really post the code, unless I post the entire project.

Yes, the code had been working fine without the lines shorted.


----- Original Message ----- =

From: "Mauricio Giovagnini" <maugiovagnini@yahoo.com.ar>
To: "Microcontroller discussion list - Public." <piclist@MIT.EDU>
Sent: Friday, November 20, 2009 11:52
Subject: Re: [EE] AsyncPro question



Vitaliy escribi=F3:
> Not using flow control, it's basically a three wire interface (Rx, Tx, =

> Gnd)
> with Rx shorted to DCD.
>
> The program is written in Delphi 7.
>

I admit I haven't wired DCD shorted to the RX pin, and I
will not but just to know , can you post your code? Can you
make your code work without shorting those lines?




-- =

------------------------------
Mauricio Giovagnini (Maunix)
www.maunix.com.ar
Cordoba, Arg.
LinkedIn Profile: http://www.linkedin.com/in/mgiovagnini

-- =

http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist =


-- =

http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist