PICdude-3 wrote:
> 
> Doing the math for an SC4517A buck regulator using their datasheet,  
> and right off the bat it asks me for something I'm not sure of --  
> peak-to-peak inductor current.  I'd think that I should just specify  
> the in/out voltages, output current and the output ripple voltage, and  
> it would then determine the peak-to-peak inductor current, which would  
> then tell me what inductor I would need.
> 

The data sheet says that the switch in your chosen part is rated for 1.5A...
so I would take that as the peak inductor current... cos any higher risks
burning out your IC.

PICdude-3 wrote:
> 
> Some other Q's ...
> 
> - Some inductor datasheets only state Max Current.  Would this be Irms  
> or Isat?
> - Is it okay to drop in an LDO after a buck converter to really smooth  
> things out?  Yes, I'd have to raise the buck output voltage.
> 

Just guessing, but I'd assume that an inductor's "Max Current" would be the
highest design current before saturation. Otherwise, maybe it's the max
current before the inductor bursts into flame... :O

By LDO, do you mean a linear regulator? You can do that but it's kind of
overkill. I expect that the buck regulator should be "stiff" within its
designed output range, and any ripple at the switching frequency (~ 1 MHz)
is easy to filter out.

HTH...

-- 
View this message in context: http://old.nabble.com/Buck-specs---inductors-tp26354258p26396491.html
Sent from the PIC - [EE] mailing list archive at Nabble.com.

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist