Peter Onion wrote:

> I'm building a PIC circuit to interface to a very old computer that
> uses 0v for "1" and -10V for "0". (http://www.youtube.com/watch?v=8EKBNfm5B4U)
> 
> It will make for simpler interface circuits if I run the PIC from 0V
> and -5V.  (I.E. 0V on Vcc pins and -5V on Gnd pins). 
> 
> Are there any issues with doing this ?  

People already responded and told you that voltages are relative and
that it works. Which is mostly correct.

What you may need to keep an eye on are grounding issues. These are a
bit more complex when you have grounds on different levels. What you see
on your PIC circuit as ground is not a ground anywhere else, AFAICT, nor
a low impedance point anywhere else. 

Depending on the power supply situation on this old computer, using the
-10V as your PIC ground may have the advantage that you can connect your
PIC ground at least to something with low impedance on that computer
(assuming that there is a -10V supply rail with a low impedance). Level
translation is just as simple.

Of course power supply isolation is imperative :)

Gerhard
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist