I believe what Jan-Erik is pointing out is that according to the 18LF2520
datasheet the MCLR pin *cannot* be configured as an output. It is either
configured as MCLR or as an *Input* - not an Output. See section 4.2 and
section 10.5 in the 18LF2520 datasheet.

Your original e-mail stated that MCLR was configured as an output for an
LED.

-- Mark

> -----Original Message-----
> From: piclist-bounces@mit.edu [mailto:piclist-bounces@mit.edu]On Behalf
> Of Quintin Beukes
> Sent: Tuesday, September 22, 2009 12:23 PM
> To: Microcontroller discussion list - Public.
> Subject: Re: [PIC] Re: Static Reboot
>
>
> I only sent the thread today, so you didn't miss anything. What I
> meant by the e-mail is that he already thought of and checked the
> mentioned (yesterday).
>
> Quintin Beukes
>
>
>
> On Tue, Sep 22, 2009 at 6:56 PM, Jan-Erik Soderholm
> <jan-erik.soderholm@telia.com> wrote:
> > Quintin Beukes wrote:
> >> He confirmed that he did check on that yesterday and they are all
> >> configured as outputs.
> >> Quintin Beukes
> >>
> >
> > OK, I have not seen this thread until today.
> > Then check the *input* MCLR-pin that is used
> > as an output (which it can't be).
> >
> > --
> > http://www.piclist.com PIC/SX FAQ & list archive
> > View/change your membership options at
> > http://mailman.mit.edu/mailman/listinfo/piclist
> >
> --
> http://www.piclist.com PIC/SX FAQ & list archive
> View/change your membership options at
> http://mailman.mit.edu/mailman/listinfo/piclist
>
>



-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist