Philip Pemberton wrote:
> Geo wrote:

>> Can you lay out that part of the pcb with tracks running on both sides 
>> (1/2 the width).
> 
> You mean just use a double sided board and run the same tracks on both 
> sides?
Yes - if you can use right angle connectors it is often possible to 
solder the pins top and bottom  - otherwise just drill a hole and solder 
a wire then trim it off to join the upper and lower layers. It may be 
necessary to widen the track slightly from that "via" to the connector 
or device pin (or bend the "via" wire over and solder it along the last 
couple of mm.)

George Smith
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist