In SX Microcontrollers, SX/B Compiler and SX-Key Tool, robotworkshop wrote:

The SX48 is nice since it gives you more memory, more I/O, and two 16-bit hardware timers.  It isn't too hard to solder by hand.  I still have a few of the SX48 OEM full kits left ($29.95 each) that are shown in the thread below:

http://forums.parallax.com/forums/default.aspx?f=7&m=194701

I also have quite a few blank PCB's which are great for mounting the SX48 processor.  Just add a 4-pin header and solder the leads to the PCB and it is probably on of the best methods for using the SX48.  The blank boards are now $4.95 each but drop down to $3.95 if you want 10 or more.

Another option is to use this other board but you have to make an adapter for programming since it lacks the 4-pin header.  It is a very in-expensive way to use the SX48!

http://forums.parallax.com/forums/?f=5&m=366382&g=366382#m366382

If you have any interest just send me a PM.

Robert

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=377097#m377139

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2009 (http://www.dotNetBB.com)