On Sat, Aug 15, 2009 at 7:55 PM, Olin Lathrop<olin_piclist@embedinc.com> wr=
ote:
> A reed switch is not a good choice. =A0This is usually done with a perman=
ent
> magnet between two spokes of the back wheel as far radially outward as
> possible and a pickup coil on the frame. =A0A little analog electronics a=
nd
> you get a pulse into the PIC once per wheel rotation.

Good idea, but the analog electronics part is wayyyyy too complicated
for me. But I'm going to go for it as I can already see an advantage
with the analog solution: if I were to use a reed switch, it may
rapidly switch on and off if the magnet stalls near the switch.
However, with a coil, it is possible to filter that out.

This approach also raises a few more questions:

* What kind of coil would need to be used? Thickness? Resistance?

* Would a coil pulled out of an analog clock work? (Was formerly used
in the clock to move the seconds hand.)

* How much coil is needed and how will it be configured physically?
Will it be wrapped around a pencil, for example?

* I'll look at the signal produced by the coil through an
oscilloscope, but what other electronics is needed to isolate the
wanted signal? Or can a PIC alone and it's A to D converter tackle the
task?

I'll have to do some reading on analog filter design.

-- =

http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist