----- Original Message ----- 
From: "solarwind" <x.solarwind.x@gmail.com>

> Could you please provide an example? I don't understand why you would
> need to reverse the design if all you are making is a single sided PCB
> with only through-hole components on one side (the FR4 side, not the
> copper side).

I sent that info before you sent your 
drawing showing how you did it.

Some people do not take into account
that it flips over when they iron it on. 
With this in mind you must lay it out 
with the right view.  If you don't then it 
will be backwards on your board.


Derward Myrick


-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist