On Wed, Aug 12, 2009 at 5:17 PM, Herbert Graf wrote: > On Wed, 2009-08-12 at 16:46 -0400, solarwind wrote: >> On Wed, Aug 12, 2009 at 4:35 PM, William "Chops" >> Westfield wrote: >> > Can you put up photos of the actual board (both sides)? >> >> I will try, once I find my camera. >> >> > You didn't, say, forget to reverse the copper pattern? >> >> It's not necessary to reverse the pattern if you're only using through >> hole components on one side. > > Actually it is, depending on the components. > I imagine the copper is on the top of the board and he soldered all through-hole components at the top side. I've done this before on my first homemade PCBs (now I just send designs out to BatchPCB). Have you put 5V (3.3V ?) on the board and made sure there wasn't excessive current draw? Made sure the Vdd/Vss pin(s) on the actual chip see the appropriate voltage? -Scott -- http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist