> -----Original Message-----
> From: piclist-bounces@mit.edu [mailto:piclist-bounces@mit.edu] On
Behalf
> Of solarwind
> Sent: 11 August 2009 13:31
> To: PICLIST
> Subject: [EE] Tungsten Carbide Bits
> 
> I just received my order of 1/32" tungsten carbide bits and so
> proceeded to drill my unfinished PCB... WITHOUT a drill press.
> 
> You guys exaggerated wayyyy too much on how easily these bits snap

To be fair, 1/32" is still quite a large drill by PCB standards.  The
small one only take the tiniest amount of misalignment to snap.

Mike 

=======================================================================
This e-mail is intended for the person it is addressed to only. The
information contained in it may be confidential and/or protected by
law. If you are not the intended recipient of this message, you must
not make any use of this information, or copy or show it to any
person. Please contact us immediately to tell us that you have
received this e-mail, and return the original to us. Any use,
forwarding, printing or copying of this message is strictly prohibited.
No part of this message can be considered a request for goods or
services.
=======================================================================

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist