In SX Microcontrollers, SX/B Compiler and SX-Key Tool, JonnyMac wrote:

The program is fine -- I just ran it again and will post a screen shot to prove it.

1. Stop shotgunning ideas that you "hope" will work -- as the president would put it, this is "acting stupidly" (out of ignorance, anyway)

2. Check your connections.  Since serial ports can be all over the place direct connections are a bad idea (imho) but if you're going to do it you should have it like this:

SX.RX <------ 22K -------  DB-9.3 (PC TX)
SX.TX  -------------------> DB-9.2 (PC RX)
GND    --------------------  DB-9.5 (GND)

Using this direct connection you must set your program Baud constant to "N9600".

The latest version of the SX/B compiler is 2.00.30.  You can find this in the SX-Key IDE About dialog by clicking on the version number until the SX/B version is displayed.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=372213#m373241

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2009 (http://www.dotNetBB.com)