In SX Microcontrollers, SX/B Compiler and SX-Key Tool, robotworkshop wrote:

I've always connected it to ground when it isn't needed.  On my SX48 OEM module I just solder bridge that pin (48) to the Vss pin (47) next to it.  By leaving the solder bridge off, that pin is accessible from a pad near the pin.

Robert

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=369356#m371627

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2009 (http://www.dotNetBB.com)