Some tips :
http://www.electro-tech-online.com/general-electronics-chat/94601-diy-toner-
transfer-paper-cheap-easy.html
http://www.electro-tech-online.com/general-electronics-chat/95167-paper-wars
-cheap-magazine-paper-vs-rip-off-proprietary-paper.html

Also on instructables, there was some more instructables and threads. One
tip was to expose the pcb to etchant (FeCl3) for a few seconds and then
rinse the board, it is supposed to create pits onto the surface of the
copper that will allow the toner to adhere to the copper.

Also
http://www.instructables.com/id/Sponge-Ferric-Chloride-Method-Etch-Circuit-B
o etching times with a sponge is fast.

>
>I've tried this a few times and it's not working. I printed my PCB
>design onto photo glossy laser paper (will try magazine paper next)
>and then I iron it onto the copper board. Some parts stick, but some
>parts don't stick at all.
>
>Any tips?

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist