On Wed, Jul 15, 2009 at 6:30 PM, Bob Blick wrote: > Steel wool or green scouring pad on the copper for some tooth. Used that, then that + sand paper on the second try. Still failed. > Wash and dry the board thoroughly. Did that. Still failed. > Use a few pieces of paper on top of the toner carrier paper when you > iron as a cushion for even pressure. You might need higher heat. Did that. Iron is on highest temperature (linen mode). Stil failed. > Before peeling, soak the board in water afterward until the toner > carrier sheet almost dissolves. My paper is pretty thick. It wont dissolve. > Touch up with a red Staedtler Lumocolor pen before etching. I shouldn't need to do that. There is too much not sticking. I tried magazine paper. All of it stuck - but none of it cleanly. There were holes all over the place and it was really messy. The photo paper gave the sharpest results but some parts didn't stick and it's really annoying. -- http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist