In SX Microcontrollers, SX/B Compiler and SX-Key Tool, rf98 wrote:

Using my sxkey.exe    (   Help-About says IDE version 3.10  )

 

I have this problem:  Programs I wrote 3 years ago now have an assembly error:

 

    [b]Error 45, Pass 1: Label must begin in column 1[/b]

 

I was able to have the ASM source, including the labels, indented in my previous SX52 and SX48 programs, so why do I now get this error?

The error goes away if I left justify the labels,  but I have lots of programs with hundreds of lines each, and the indents are very useful for structuring the code.

 

This always worked before.  

 

Under Run>Configure I un-checked [b]'Local labels must start in column 1'[/b].  

 

Is a Windows XP problem?  ( The programs were previously written and assembled in Windows 98 and Windows ME)

Or perhaps I grabbed an earlier IDE release that did not allow indented labels?

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=364563

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2009 (http://www.dotNetBB.com)