I don't remember exactly where. When I was communicating with Walter (It is pity he recently left Microchip and PICKit 2 team.) for our BB0703+ design and 3-in-1 mini-lab design, he mentioned some headache on 2550 BOR too. If I remembered right, the BOR used to be "on" in older PICKit 2 firmware releases. The newer ones got it all turned off. Not sure about the PICKit 2 old firmware on POR. But I can see it is off on most recent releases. I have no issue on POR and BOR on all my own PIC based design. It is quite strange. Funny N. Au Group Electronics, http://www.AuElectronics.com ________________________________ From: Xiaofan Chen To: Microcontroller discussion list - Public. Sent: Thursday, June 4, 2009 5:27:56 AM Subject: Re: [PIC] PIC18F6410 start-up problems... On Thu, Jun 4, 2009 at 2:20 PM, Funny NYPD wrote: > Not just you. > Even Microchip development team can not figure out how to use the > PIC18F2550 POR and BOR properly for their PICKit 2 design. So those > two features were simply turned off to save a headache. Where did you get the information? Care to share? The BOR features are turned off because of other reasons. -- Xiaofan http://mcuee.blogspot.com -- http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist -- http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist