On Sun, May 3, 2009 at 8:32 PM, Joseph Bento <joseph@kirtland.com> wrote:
> This is a website I frequently refer to regarding the CAN specification:
>
> http://www.interfacebus.com/Design_Connector_CAN.html
>
> You essentially need just three wires - CAN High and CAN Low in a
> twisted pair, and Ground. =A0High noise may require shielding.
> Termination is via a 120 ohm resistor, though in the case of National
> Instruments equipment I've worked with in the past, that resistor was
> inclusive in the interface.
>
> Joe

Thanks for the website! It's really helpful.

-- =

http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist